WE’RE HIRING. CLICK FOR TEXTON CAREERS!

Battery Operated

Rollease Push 15 Remote – Creating Groups

The new Rollease/Volta Push 15 remote now gives you 15 individual channels, 5 dedicated group channels as well as a built in all channel(Zero). Setting up groups: Select the group channel you want to use (A-E)Press and hold the (-) + the stop button for 4 seconds. A...

Troubleshooting: Rollease Li-On Motors

The motor is not responding. Make sure the motor is charged up.Make sure the controller has a good battery and is installed correctly.Adjust the antenna on the motor.Make sure the distance from the remote to the shade is in range.Reset and reprogram the shade. The...

Rollease Li-On Motor Programming Guide

Note: These instructions start as if the shade has never been programmed. If the shade has been previously programmed or needs to go back to factory default (So you can start from the beginning), please follow the “Resetting to factory default” directions before...

Troubleshooting: Somfy Li-On Motors

The motor is not responding. Make sure the motor is charged up.Make sure the controller has a good battery and is installed correctly.Adjust the antenna on the motor.Make sure the distance from the remote to the shade is in range.Reset and reprogram the shade....

Somfy Li-On Motors Programming Guide

Note: These instructions start as if the shade has never been programmed. If the shade has been previously programmed or needs to go back to factory default (so you can start from the beginning), please follow the “Resetting to factory default” directions before...

Troubleshooting: Somfy R28 Battery Motor

The shade loses its limits after programming. Make sure to complete the programming sequence to set limits. The shade won’t work. Make sure the motor has power.If using a battery wand, make sure the batteries are good and they are in the tube properly.Reset and...

Somfy R28 External Battery Programming Guide

Note: These instructions start as if the shade has never been programmed. If the shade has been previously programmed or needs to go back to factory default (so you can start from the beginning) please follow the “Resetting to Factory Default” directions before...